Operation
• Operate and display from 1 to 4 channels in selectable frequencies :
- Single channel/four frequency
- Two channel/two frequency each channel
- Four channel/single frequency each channel
• Encoder knob for scrolling through menu
• Enter, cancel,null,clear and disply controls
• Four programmable function keys(F1-F4)
|
Display
• 12" diagonal color LCD, flat panel screen
• Selectable X/Y impedance plane display,O-scope X,Y or X&Y
• Selectable display mode including eddy current and strip chart. One channel or up to four channels.
• Sensitivity scaling of 0.2, 0.5, 1.0, 2.0, 5.0 volts per division
• O-scope sweep speed of 10ms/div to l ms/div
•Auto clear of 0-10 seconds in 1-second increments
• Variable persistence of 0-10 seconds
• Electronic null <2 seconds above 1KHz probe frequency
• Rotation (phase) is 0-359 degree in 1-degree increments
|
Frequency
• Range from 10Hz to 10MHz
• 2, 4 and 7.0 V output adjustable on each channel with output impedance of 10 ohms |
Gain
• 0-99.9dB in 0.1 dB steps |
Sensitivity
• 200 V/ohm maximum |
Filter
• Variable band pass, low and high pass in X&Y axis
• Filters adjustable in 1Hz increments from 0 to 1KHz |
Probe Types
• Absolute, differential, reflection and differential reflection |
|
Data Storage
• Programmable test setups : Internal memory will store up to 100 test setups for easy retrieval.
• Data storage : Dependent on capacity of compact flash memory card
|
Gate/Alarm
• Rectangular, elliptical, high and low bar with ＋ or －audio and voltage outputs
• Internal audio alarm
• TTL and open collector outputs for driving programmable Logic Controller(PLC) relays and external audio and visual devices. |
Documentation
• Printers include Hewleft Packard via the parallel port
• Selected menus and header can be printed in full color from an external computer
• Print screen allows printing of the current display and settings |
Input/Output data
• RS-232 serial port for remote control
• Parallel, USB, Ethernet and RGB video out
• Analog : 16bit A/D and D/A conversion @＋/－10V
•Probe connections via four 8 pin Burndy |
External Encoder Inputs
• 4 External 2phase encoder inputs allow position information to be synchronized to the eddy current signals
|
Power
• 110/220 VAC |
General
• Dimensions : 17" wide x 8.7" high x 18. 5"deep
• Weight : 57 lbs
• Operating temperature : 32 to 158 F(0-70C)
• Storage temperature : -4 to 158 F (-20-70C)
|
Additional features
• The eddy current impedance plane display and the X&Y strip chart recording can be displayed.
• Configured for 19" standard, climate controlled and/or dust free rack mount cabinet. |
|
